Arrow

NRGi

Office buildings

2007

Arrow iconProject overview

Address : Dusager 22
8200 Århus N
Denmark
Contact person : Sales Office Denmark
wicona@wicona.dk
- Denmark

Architect : Schmidt Hammer Lassen Architects - Aarhus - Denmark

Fabricator : marius hansen facader A/S - Viborg - Denmark -

Other planning committee : LB Consult A/S - Århus - Denmark - / Hoffmann A/S - Glostrup - Denmark -

Project details :

NRGI Denmark domicile in Aarhus the Building is approximately 4500 m2. The building is a office for 125 employees. The facade construction is based on WICTEC 50 solution with slim line pressure plate. All visible profiles and panels have been gold anodized. The inclination of the facade in the ground floor is +37°. The 1st and 2nd floors inclination is respectively +16° and -16°. The building has been constructed to use the least amount of energy and heating, and thereby the building can serve as a practical demonstration object in energy-efficient solutions and technologies.

Arrow iconTechnical details

Facade systems

WICTEC 50

Filigree look without any change in appearance to the inner mullion and transom gaskets Ideal for vertical and polygon façades, sloped glazing and spatial structures Individual design thanks to a wide range of profile geometries for the structural and glazing profiles Uf for standard version up to 1.2W/m²K infill thickness 3 - 51mm Reliable glass load transmission (up to 4 kN), with adapted transom-joint technology Overlapping and secure drainage at the cross point, without mechanical mullion processing, ensures tried-and-tested impermeability Broad selection of profiles enables economic adaptation to structural requirements, with the additional option of internal reinforcement Glazing from outside featuring single- and/or two-part pressure and cover profiles Design options with concealed or visible screw fixture Extensive solutions for structure junctions and conservatories appearance similar to structural sealant glazing (SSG) facade Substitute silicon joint of SSG facades, no bonding and thus no SSG approval necessary Integrated pressure profile, available flat on or flush with the glass Elevation width 43 or 51mm
Built:: - Integrated pressure plate